|

INSTALLATION
The BioLet Basic is easy
to install!

Make a hole in the ceiling and roof for the ventilation pipe.
Push the outer pipe into the roof flashing and seal it carefully.
Make a hole in the floor or wall for the drain tube.
Push the drain tube through the hole made for it.
Empty the compost starter into the BioLet.
The BioLet NE is ready to be used.
Drainage System
The BioLet NE doesn't have an electric heater to assist the
evaporation of excessive liquid so, it will not fully evaporate
the total volume through the vent. Therefore, it's necessary
to install a small drainage system unless the excess liquid
can be drained into an existing septic or holding tank. An
outdoor or indoor soil/planting bed will do or the excess
liquid can be collected into a container and later be used
to water and fertilize nitrogen-loving plants, or some other
methods of disposal as described in the owners manual.

Dilute with 75% water before watering nitrogen-loving plants.
ALWAYS CONSULT YOUR LOCAL ENVIRONMENT HEALTH OFFICER BEFORE
INSTALLING YOUR DRAINAGE SYSTEM!
Top

TECHNICAL
SPECIFICATIONS
Capacity:
4-6 people - Full-time use
4-6 people - Part-time use
May be increased by the addition of an auxiliary
12VDC ventilation fan.
Weight Limit:
350 lb
Required Room Temperature: 64F
during periods while the toilet is in use.
Measurements and Weight:
|